429
4-5. Using the driving support systems
4
Driving
The parking assist lights of the Multi-
terrain Monitor system are installed in
the locations shown in the figure.
● Some foreign matters may not be
removed completely after cleaning. In
this case, rinse the rear camera lens
with a large quantity of water and then
wipe it clean with a soft cloth damp-
ened with water. Do not strongly rub
the rear camera lens, as it may be
scratched and will not be able to trans-
mit a clear image.
● Washer fluid is sprayed onto the rear
camera lens surface. Therefore, the
ice, snow, etc. adhering around the
rear camera such as the garnish can-
not be removed.
● Use fluids that are appropriate to the
outside temperatures, in order to pre-
vent the washer fluid from freezing.
● When washing the vehicle, do not let
water from the high-pressure washer
directly hit the nozzle. Due to the
shock from the high pressure water, it
is possible that the device may not
operate normally. Also, the water may
enter the nozzle injection opening and
freeze. It causes the washer fluid not to
spray properly.
● Do not subject the nozzle to sudden
change of temperature such as by
pouring hot water into the nozzle
under the cold weather.
● The washer fluid will need to be
replaced more often when the rear
camera cleaner system is frequently
used. Because the washer reservoir is
shared with the windshield washer.
● Do not strike or hit the nozzle or sub-
ject it to a strong impact, as the nozzle
installation position and angle may be
changed.
● When the vehicle got strong vibration,
it may be difficult to see the image due
to the washer fluid drop from the noz-
zle.
● When activate rear camera washer, it
also activate rear windows shield
washer simultaneously.
● When cleaning the rear camera, it may
be difficult to see the image due to the
washer fluid. In this case, directly
check the surroundings of the vehicle.
● If washer fluid remains on the rear
camera lens surface after cleaning.
Then the image may be difficult to see
at night due to the height or inclination
of the headlights of the vehicle behind.
Parking assist lights
■ Parking assist lights
● Make sure to observe the following
precautions, otherwise the Multi-ter-
rain Monitor system may not operate
correctly:
• Do not apply excessive force to a light
or subject it to a strong impact. Doing
so may cause the position or installa-
tion angle of the light to deviate.
• Do not remove, disassemble, or mod-
ify the lights as they have a waterproof
construction.
To Next Page
Loading...
