5.1 Speaker Setup
Make the following settings for the built-in 5.1
channel surrounds decoder.
1. Press
SETUP.
2. Use
U u
to select AUDIO menu and then
press
i
.
3. Use
U u
to select [5.1 Speaker setup] menu
and then press
i
.
4. Press
ENTER
The [5.1 Speaker setup] appears.
5. Use
I i
to select the desired speaker.
6. Adjust options using
U u I i
buttons.
7. Press
RETURN to conrm your selection.
Return to the previous menu.
Speaker selection
Select a speaker that you want to adjust.
NOTE
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
Size – Since the speaker settings are xed, you
cannot change the settings.
Volume – Press
I i
to adjust the output level
of the selected speaker.
Distance – After you connected speakers
to your unit, set the Distance between the
speakers and your listening point if the
distance of Center or Rear speakers is bigger
than the distance of Front speakers. This allows
the sound from each speaker to reach the
listener at the same time. Press
I i
to adjust
the Distance of the selected speaker. This
distance is equivalent to a dierence of the
distance between Center or Rear speaker and
Front speakers.
Test – Press
I i
to test the signals of each
speaker. Adjust the volume to match the
volume of test signals memorized in the
system.
LOCK (Parental Control)
Initial Setting the Area Code:
When you use this unit for the rst time, you
have to set the Area Code.
1. Select the [LOCK] menu and then press
i
.
2. Press
i
.
To access the [LOCK] options, you must
input the password you have created. Input
a password and press ENTER. Enter it again
and press ENTER to verify. If you make
a mistake before pressing ENTER, press
CLEAR.
3. Select the rst character using
U u
buttons.
4. Press
ENTER and select the second
character using
U u
buttons.
5. Press
ENTER to conrm your Area code
selection.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
