29
206-4272
Ez Download Utility (Cont.)
(Continued from previous page)
Update progress will be shown in a new screen. Do NOT remove the USB device while updates
are in progress. When the Ez Download process is complete, an overview of the results will
briey be displayed and then, the STB will reboot. *
11. Remove the USB memory device, and verify that the appropriate configuration/update(s) is/are
resident on the STB.
Note: If you updated the STB configuration with a TLX file, upon restart (and, if applicable,
conrmation of new video output resolution—see note below), the STB tunes according to the
Start Channel setting in the Installer Menu. If a Start Channel is specied, the STB will tune to
that channel, though in the case of FTG Mode conguration, a channel banner will only be
displayed if the Start Channel is included in the FTG Channel Map (depending on your selection
in step 9, the channel banner will display either the Start Channel’s logical channel number or
physical RF channel number). Otherwise, the STB will either return to the last channel tuned
(STB in Pass-through Mode) or tune to the rst channel in the FTG Channel Map (STB in FTG
Mode). In the latter case, remember that the channels in the FTG Channel Map are always
arranged in logical order, regardless of your selection in step 9.
Note: If you updated the STB configuration with a TLX file that included a change to Installer
Menu item 105 VID OUT FORMAT, when the reboot is complete, you will be prompted to conrm
the new video output resolution. See item 105 description on page 38 for further information.
* STB-3000s with CPU software earlier than v3.00.70 will only reboot upon completion of a TLX update if the TLX
file included a change to Installer Menu item 105 VID OUT FORMAT (see also note regarding item 105 above).
To Next Page
Loading...
Need help?
General
