To Next Page

To Previous Page

206-4272

Cloning Procedures (Cont.)

(Continued from previous page)

9. When you are ready to initiate the Teaching process, select UPDATE on the screen and then

press OK on the Installer Remote.

CANCEL

BACK

UPDATE

Channel Tuning / Channel Banner Display

Logical

Physical

TEACH TO STB (TLX)

STB MANAGER

Select USB Memory Device

USB Device 1:

Device Name

Select the ﬁle to download, and then select UPDATE below.

STB-3000-UA00001.TLX

Teaching progress will be shown in a pop-up banner at the bottom of the Teach To STB (TLX)

screen. This process may take a few minutes. Do NOT remove the USB device while Teaching

is in progress. When the Teaching process is complete, an “Updating completed” message will

briey be displayed, and then, the STB will reboot. *

10. Remove the USB memory device from the Target STB, and verify that the appropriate

conguration is now resident on the Target STB.

Note: If the Target STB was previously in Pass-through Mode, and the TLX le used for Teaching

contained an FTG Channel Map, the Target STB CPU is now in FTG Mode. Upon restart (and, if

applicable, conrmation of new video output resolution—see note below), the STB tunes according

to the Start Channel setting in the Installer Menu. If a Start Channel is specied, the STB will tune

to that channel, though, in the case of FTG Mode conguration, a channel banner will only be

displayed if the Start Channel is included in the FTG Channel Map (depending on your selection

in step 8, the channel banner will display either the Start Channel’s logical channel number or

physical RF channel number). Otherwise, the STB will either return to the last channel tuned (STB

in Pass-through Mode) or tune to the rst channel in the FTG Channel Map (STB in FTG Mode). If

the latter, remember that the channels in the FTG Channel Map are always arranged in logical order,

regardless of your selection in step 8.

Note: If you updated the STB conguration with a TLX le that included a change to Installer Menu

item 105 VID OUT FORMAT, when the reboot is complete, you will be prompted to conrm the new

video output resolution. See item 105 description on page 38 for further information.

* STB-3000s with CPU software earlier than v3.00.70 will only reboot upon completion of a TLX update if the TLX

file included a change to Installer Menu item 105 VID OUT FORMAT (see also note regarding item 105 above).

LG STB-3000 Setup Guide

Other manuals for LG STB-3000