IDENTIFICATION OF CLOSURE STAGGERING AND STOP PLATE
IDENTIFICATION OF STAGGERING AND OPENING STOP PLATE (a)
will open. When it reaches the point at which one also wishes to open leaf
b) When one of the two leafs reaches the opening desired position, give and release the step command
Depending on whether it is leaf
IDENTIFICATION OF STAGGERING AND OPENING STOP PLATE (b)
Give and release the step command
, the leaf with the undefi ned stop plate starts to open slowly.
b) When the moving leaf reaches the desired open position, give and release the step command
Depending on whether it is leaf
to defi ne the opening stop plate of the leaf
to defi ne the opening stop plate of the leaf
ive and release the step command
hen it reaches the point at which one also wishes to close
(closure staggering) give and release the step command
will close. The leaves now both move at a normal
n reaching the closure position, the green LEDS fl ash and
The automation is now programmed
. The automation is now in
If you are dissatisfi ed with the result obtained,
and repeat procedure from start.
To Next Page
Loading...
Need help?
General
