RESETTING THE CONTROL UNIT
Switch off the system’s power supply.
and switch on the system’s power supply until
moves when opening or closing the
green LEDs and left red LED fl ash alternately.
moves when opening or closing the
green LEDs and right red LED fl ash alternately.
IDENTIFICATION OF STAGGERING AND OPENING STOP PLATE
hen it reaches the point at which one also wishes to open
(opening staggering) give the step command
will open. The two leafs continue to
hen they have both reached the opening stop plate micros
IDENTIFICATION OF CLOSURE STAGGERING AND STOP PLAT
Give and release the step command
hen it reaches the point at which one also wishes to close
(closure staggering) give and release the step
will close. The leaves now both move
at a normal speed when closing.
n reaching the closure stop plate micros, the green LEDS
fl ash and the red LEDs remain lit.
The automation is now programmed
. The automation is now in
If you are dissatisfi ed with the result
and repeat procedure from start.
To Next Page
Loading...
Need help?
General
