Page 157 of 192
Warnings
• When using the locking function on HL80 check that the hand control switches are actually locked.
• Locking function on HL80 only locks the actual hand control .
• Do not sit or lie on the hand control . It can cause unintended movement of the application.
• Locking of a single channel at HL80 do not neccesarily prevent that channel from activation, if the same channel are covered by another hand
control button (e.g. at simultaneous drive) or another control unit.
• There is a risk that items with internal magnet for mounting instead of hook can disturb function of cardiac pacemaker, implantable cardioverter
defibrillators or magnetic implants!.
The HL80 hand control has an optimised ergonomic design and switch activations.
The HL80 is a lockable hand control, which makes it possible to lock or unlock one or several functions.
It is available in several different standard versions with a variation of bed symbols for easy interaction with
end-users.
Usage:
• Approvals: IEC60601-1, ANSI/AAMI ES60601-1 and CAN/CSA-22.2 No 60601-1
24. HL80 (MEDLINE
®
CARELINE
®
)
Recommendations
• Violent use of the key on HL80 can cause either damage to the keyhole or the key itself.
• If a lock key is missing, then full control over the application could be missing.
• Clean the hand control regularly to ensure good hygiene standards.
• When a defective HL80 is replaced, check that the new HL80 has exactly the same specification and fuctionality.
• Do not submerge the hand control under water.
• Unless otherwise specified or agreed by LINAK, the hand control is only intended to be used on LINAK systems.
• When changing hand controls for OpenBus™ systems, the power must be switched off.
• It is recommended to check the hand control and cable for damage and holes made by violent handling before washing the application or at least
once a year.
• It is recommended to have a parking place for the hand control on the application, where the customer ensures that the hand control does not
fall off.
For hand controls with magnet:
• If hand controls with magnet are attached to a smooth surface, a movement or twisting of the cable, for example during transport, can cause the
hand control to move and result in damage if the cable is squeezed.
• The force of the magnet depends on the thickness of the lacquering, the lacquering type, stickers, steel thickness etc. It is the responsibility of the
customer to verify that the holding force on the application is acceptable.
• It is the responsibility of the user/operator to evaluate any possible risk caused by use of permanent magnets.
To Next Page
Loading...
Need help?
General
