LINET AVE 2 - Operating the Bed; Side Rails; Description of the Control Panel for the Woman in Childbirth

31
Lowering / lifting of
back section
Nurse Call
5 Operating the bed
Warning:
Caution
The birthing bed is not designed for permanent operation – motors can only be loaded up to the
values defined on the label, i.e. 2 minutes of operation followed by 18 minutes of stand by. Excess
workload of the device may result in automatic stop. Under such conditions, authorized service action is
needed.
 Components of the product are not treated against fire. Hence, avoid handling near open fire.
If this rule is not observed, the device may catch fire.
 When handling the product, please pay attention to th e protection of a power cable against
mechanical damage, especially its insulation.
 In case of fuse replacement pay attention to correct selection of a fuse type. Fuses need not
be replaced by an authorized LINET service; it can be done by a qualified electrician.
 Pay attention to free passage of hoses, cannulae, and other free parts (in case infusions are used) so
as not to get these pinched in the moving parts of the product (rails or leaning parts may be the risk
locations).
 When positioning the product, collision with objects may occur. Keeping safe distance from other
objects is recommended in order to prevent damage and injury.
5.1 Side rails
Unremovable side rails are intended to serve as a handle for the woman in childbirth enabling her to have
more stable position during the delivery.
5.1.1 Description of the control panel for the woman in childbirth