Adjustment to any of these positions can be done by pressing the controller in the direction of the marked
arrow and turning the foot section towards/outwards the operator. Once reached, the foot section will
automatically lock in both positions.
Before folding, always make sure the foot section is in the lowest position and back section is not in
Trendelenburg position!
In case of putting aside the upholstery of t h e foot section from the bed, it must be placed on its wide
laying surface on flat surface such as ground or table. In case of lying the foot section on the edge side,
the upholstery may be damaged due to heavy weight of the part.
When unfolding the foot section, other person(s) must not interfere.
5.5.2 Lifting/lowering
The surface of the completely pulled out foot section may be lifted up to the level of the seat. All listed
positions of the foot section do not limit motoric setting of the birthing bed. Before loading the foot section,
its correct locking should be checked by short moves to the sides.
To Next Page
Loading...
