Link G4 Storm - Pre-start Checks; Initial Setup

To Next Page

To Previous Page

First Time Setup 51

11.1 Pre-start Checks

To avoid potential engine damage and wasted time, the adjustments presented in the

following sections must be made before attempting to start the engine.

For further help on any of the settings discussed below, consult the online Help in PCLink

Tuning Software. Online help can be invoked by pressing F1, or right clicking any item and

selecting ‘What’s this?’.

Pre-set-up Checks

Before attempting to configure the ECU, ensure the following tasks have been completed:

1. Ensure the ECU and all associated components are connected and correctly

wired/installed.

2. Fully charge the vehicle’s battery, as the engine will be required to be cranked during

the set-up procedure.

3. Check all oil and water levels are correct.

Connecting to PCLink Tuning Software

Use the following procedure to establish a connection between your Link ECU and PCLink

Tuning Software tuning software.

1. Make sure your laptop battery is fully charged or plugged in to mains power.

2. Connect the ECU to your laptop and connect to PCLink Tuning Software as

described in the 'Communicating with your ECU' section of this manual.

11.2 Initial Setup

After all checks described in previous sections have been performed, the ECU is ready to be

configured for a particular application. The following set-up procedure should be used on all

installations as a minimum:

Configuration and Fueling Set-up

If the ECU is to be used to control fuel injection, all of the following steps must be

performed. If the ECU will not be controlling fuel injection, then only steps 1 and 2 are

required.