SCP System • Replacing components
30 CP_SEM_60-00-00.002
Fig. 12: Opening the casing (2)
◗ Release the two connectors indicated on the flow sensor board (CPU board connection A 40 and
current supply connection A 41).
◗ Now open up the casing lengthwise (over the upper casing).
!
Caution on subsequent re-assembly: Sharp edges on the shaft angle encoder board can damage the
flat cable and/or its insulation. Ensure that the cables lie flat on the CPU board and do not touch the
shaft angle encoder board.
Fig. 13: Opening the casing (3)
To Next Page
Loading...
