3-2 CHAPTER 3: SETTING INTO OPERATION
ALPHA ST320 S2
1. TRANSPORTATION
1.1. Description
The Alpha ST320 S2 bar feed system may be delivered either on a pallet or packed in a wooden crate
according to the customer requirement. The uncrating and lifting instructions recommended by LNS must
be observed in order to prevent any injuries to persons and damaged to objects.
1.2. Unpacking
For practical and safety reasons, the bar feed system must be unpacked in a spacious, well-lit location.
1. If the bar feed system is received in a crate, start by unscrewing the top panel.
2. Remove the front.
3. Remove the side-walls.
• A pusher and guiding channel set is
mounted in the bar feed system (A).
Depending on the purchase order,
other sets may be delivered in a
separate box.
• The interface plug/cable is tightened
with remote control cable. Interface
diagram is placed inside the electrical
cabinet. Documentation, tools, finger
chucks, lathe connecting parts, front
tube/telescopic tube, air tube... are
packed inside the accessories box.
3
A
To Next Page
Loading...
