LNS Alpha ST320 S2 - Material Clamping Device

CHAPTER 7: GENERAL DESCRIPTION 7-13
ALPHA ST320 S2
5. MATERIAL CLAMPING DEVICE
5.1. Description
The material clamping device serves to fix the material when the pusher is proceeding to the insertion or
retraction. Independently of the material, the diameter, or the bar profile, the clamping blades are
invariably the same and do not require any adjustment.
5.2. Layout of the elements
Designation Article No. Description
A - Clamping blades
B - Clamping jaw in clamped position sensor.
C - Clamping device cylinder
5.3. Replacement of the blades
The clamping blades must be replaced when worn out. Proceed the
procedures below :
1. Unscrew the screws (A) the removed the worn blades (B).
2. Install the new blades and tighten with the removed screw.
A
A
B
A
B
C