SECTION 2.88
When the battery is in seriously low condition, Lockly™ will make contin-
uous beeping sounds in addition to the flashing low battery icon on the
touch screen. You should replace batteries immediately to avoid your
smart lock from shutting down.
When your smart lock low-battery warning alert finally dies, you will have
3 chances to unlock your smart lock either by a password, APP or
fingerprint. If the unlock was successful, the low-battery warning alert will
be on for 1 minute. After which, the smart lock will go to dead-battery
mode and will lock auto lock in 5 seconds and the screen will display a
low-battery icon.
Dead Battery
Condition Indicator Solution
Low Battery
Battery Icon on the
display keypad will
light up to indicate
low battery.
Replace batteries immedi-
ately to avoid battery
failure. Lockly™ Secure can
still operate up to 300 cycles
in low battery condition.
When there is no
display and sounds;
and screen is
non-functional.
Replace batteries immediately.
Supplied physical backup keys
can be used to unlock the
door. Alternatively, use a 9V
battery as shown below to
temporarily activate the lock.
Your Lockly™ will automatically
detect battery polarity. So hold your
9V
battery lead in place against
bottom of
the Lockly™ to temporarily
activate
t
he screen to enter your
Access Code.
Be sure to hold the
9V battery against
the contact
points located at the bottom
of the
lock until you have successfully
unlocked your door with your
Access
Code. Once unlocked,
batteries should
be replaced imme-
diately.
2.8 Low Battery
_
+
9V
Alkaline
battery
To Next Page
Loading...
Need help?
General
