SECTION 3.3
12
3.3 Adding an Access Code
While in Programming Mode, select “1AD” to add an Access Code. If you
are not in Programming Mode, please see Section 3.2 to enter Program-
ming Mode.
After pressing “1AD” press “Pd” to add an Access Code.
Enter your new 6 - 8 digit Access Code
and press when you are finished.
You will then re-enter the code to confirm
your new Access Code.
Remember, just touch the digit you need
within the circle around each 3 numbers.
There is no need to touch the exact
location of the number. For example,
based on the example image to the left, if
you need “1”, you can touch the upper
left button or the lower right button. For
“6”, you would touch the upper right
button.
To Next Page
Loading...
Need help?
General
