SECTION 3.110
3.1 Configuring Access
The Default Access Code is
NOTICE
1 2 3 4 5 6
How to Use the Keypad
There are a total of five (5) buttons on the
keypad as shown in the example image
to the left. The numbers in each button
may differ than what is shown on your
device than what is displayed here.
To enter your required digit, just simply
press the circle where your number is
shown. You do not need to press the
actual number as anywhere within the
circle will suffice.
The button on the bottom is the OK
button. You will be pressing this button
when you are done entering your Access
Code.
Your new Lockly™ Access Code can be any combination of 6 to 8 digits.
Once a new Access Code is entered, the Default Access Code of 123456
would be deleted.
A Maximum of 8 sets of Access Codes can be stored for use.
OK Button
To Next Page
Loading...
