Logos Quantom Tx - Safety Precautions

4
Safety Precautions
Instrument Safety
General safety
Operate the instrument in the conditions described in the Operating Conditions.
Install the instrument on a level and sturdy surface. Avoid vibrations from other devices.
Do not touch components with wet hands.
Use components provided or authorized by Logos Biosystems. If the proper combination
of components is not used, product safety cannot be guaranteed.
Use only the power cord and AC adapter provided by Logos Biosystems. If the proper
power cord and AC adapter are not used, electrical safety of the product cannot be
guaranteed.
Ensure that the input voltage is compatible with the power supply voltage of the product.
Connect the grounding terminal of the instrument and electrical outlet properly. If the
instrument is not grounded, electrical safety of the product cannot be guaranteed.
Turn on the instrument only after connecting the power cord and AC adapter to both the
power source and the instrument. Turn off the instrument before disconnecting the power
cord and/or moving the instrument.
Disconnect the power cord in the case of abnormalities.
Do not hold the slide slot while it is in motion.
Protect USB drives from being infected with viruses and malware.
Operating conditions
Operating Power
100 - 240 VAC, 1.2 A
Electrical Input
12 VDC, 3.3 A
Frequency
50/60 Hz
Installation Site
Indoor use only
Operating Temperature
10 - 35°C
Maximum Relative Humidity
10 - 80%
Altitude
≤ 2,000 m
Pollution Degree
2
Instrument disposal
Follow the rules and regulations of your local government.
Instrument disassembly
Do not disassemble the instrument in any event as this will invalidate your warranty.
If the instrument is damaged or malfunctioning, contact your local distributor or Logos
Biosystems.
Personal Safety
Safety guidelines
Read all user manuals thoroughly before using the instrument.
Keep all user manuals in a safe and accessible place for future reference.
Read all safety data sheets before storing, handling, or working with any reagents.
Wear appropriate personal protective equipment (PPE) when handling reagents and cell
samples to avoid exposure.
When using toxic agents, radioactive materials, or pathogenic microorganisms belonging
to WHO Risk Groups 2-4, follow national laws and regulations for biosafety level
requirements.
Waste disposal
Do not reuse QUANTOM
™
M50 Cell Counting Slides. Used slides must be disposed as
biohazardous waste according to the rules and regulations of your local government.