5. Leveling method
You can manually click the XY zero
and Z zero in the Movement
interface, then unlock, manually
move the hot bed and the nozzle,
and then adjust the leveling nut so
that the distance from the nozzle to
the hot bed is about one A4 paper
thickness。
Turn on the machine, click the levelling button, click
the four buttons in turn, the nozzle will move to the
corresponding position correspondingly. After
waiting to move to the corresponding position, you
can manually adjust the hand nut to adjust the
distance between the nozzle and the hot bed to
approximately one A4. Thicken the paper, tighten
the screw [tighten counterclockwise], and increase
the distance between the heating plate and the
nozzle. Loosen the screw [screw in the clockwise
direction] and the heating plate will be close to the
nozzle. Adjust the other three points in turn to
complete the leveling.
To Next Page
Loading...
