3.Power regulation
4. Pre-use inspection and leveling
If the access voltage is 220V,
please adjust the power supply in
the control box to 220V, please
be sure to confirm before
powering on. Otherwise it will
burn the power
If the access voltage is 110V, please
adjust the power supply in the control
box to 110V, please be sure to confirm
before powering on. Otherwise it will
burn the power
shake the hot bed and the nozzle by hand to see if there is
any gap or sway. If there is any shaking, you can use an
open-end wrench to screw the hexagonal sleeve on the
corresponding pulley, which can adjust the tightness of the
hot bed and the nozzle.
Tip: After the machine is assembled, please
arrange the cable and move the three-axis
motion by hand to see if it affects the
movement and the jamming phenomenon.
To Next Page
Loading...
