Question 5: When the machine is leveled, when the
nozzle moves to the left, it can be leveled normally.
When the nozzle moves to the right, it is found that the
nozzle and the hot bed are far apart or very close. What
should I do if the spring is adjusted to the limit position?
Question 6: After the machine is heated, the spit is
normal, but when the first time of printing, the silk falls
on the platform and curls, and then after printing a few
layers, what should I do if it is off the platform?
If this happens, the X-axis beam is generally loose. At this time, the hex socket on the
right side of the machine can be adjusted with a wrench to adjust the tightness
1. After the user gets the 3D printer, if the leveling is found to be curled on the
first layer of silk, it feels like it is gently falling on the platform. It can be judged
that the leveling is not adjusted, and the nozzle is too high from the hot bed. ,
2. At this point we need to re-level, the quality of the leveling can largely
determine the success rate of the part printing.
3. In addition, in order to ensure good contact between the model and the
platform, we can set the larger plane of the model face down when slicing,
and can also be set in the slicing software to add Raft to the model, which can
make the model stick to the platform. Firm.
To Previous Page
Loading...
