Question 3: What should I do if the machine does not
retreat when the material is returned?
Question 4: What can I do if I can't power off?
1. Before returning the material, please
heat the nozzle first, and then withdraw
the consumables as soon as possible. If
you can't pump it, you can re-feed the
material with the advanced material, and
melt the extruded block formed at the
end of the consumable in the nozzle.
2. When withdrawing the consumables,
before the end of the consumables
reaches the pneumatic joint, we will
usually pull the Teflon directly from the
Teflon and cut the end of the
consumables.
3. Because the end of the
consumables in the nozzle will be
deformed by heat, if the end
deformed consumables are directly
pulled out, it may get stuck to the
pneumatic joint or the limit switch
that damages the broken material
detection (the limit switch for the
broken material detection is single)
Towards).
If the power is suddenly turned off when the part is first printed,
the machine will not save the print data. Unless the height of the
print exceeds 0.5mm, the power failure will be supported. If the
height is less than 0.5mm, it is recommended to reprint directly.
To Next Page
Loading...
