Safety Precautions
1) The temperature of the nozzle parts can reach 250°C during the
operation of the machine. To ensure your safety, it is forbidden to touch
the model and nozzle directly with your hand while the printer is printing
or cooling.
2) During the operation of the machine, it is forbidden to reach into the
machine to prevent pinching.
3) The working voltage is 110~220V AC voltage 50HZ AC. The three-pin socket
must be grounded. Do not use other power sources to avoid damage to
components or fire, electric shock and other accidents.
Note: Before powering on, please check whether the input voltage value
of the switching power supply meets the voltage standard of the country
or region.
4) When the machine is working continuously for ≥ 96 hours, it should
be stopped for 1-3 hours.
Consumables
Consumables are not used after unpacking or for a long period of time after
the print model is completed. The consumables should be taken out of the
printer and sealed to prevent the consumables from being exposed to the
air for a long time, causing moisture and affecting the print quality.
At the same time, when the consumables are removed The front end of the
consumable should be fixed on the tray to avoid consumables and affect
the next print.
To use this printer, it is recommended to use the supplies provided by
the company. At present, the quality of consumables sold in the retail
market is uneven, and printing is prone to breakage.
Staggering and clogging the printer nozzle, etc., and irreversible damage
to the heating components of the nozzle, the extrusion motor and the
extrusion gear. The company will not guarantee the printer due to the use
of consumables other than our company.
Environmental requirements
Temperature requirement: 10°C ~ 30°C, humidity requirement: 20%~50%,
within this range, the 3D printer can work normally; beyond this range,
this 3D printer will unable to achieve the best print results.
To Next Page
Loading...
