Longtec TR700 - Parameter List of Calibration in Kind; Parameter List of Digital Calibration

TR700 Instruction Manual
47
7.4. Parameter List of Calibration in Kind
Table 7-2
CAL1
Name
Defaul
t
Setting
Parameter range
Descriptions
C1.dEC
i
Position
of decimal
point
0
0-4
0：No decimal place 12345
1
：
1 decimal places 1234.5
2：2 decimal places 123.45
3：3 decimal places 12.345
4：4 decimal places 1.2345
C1.d
Division
1
1、2、5、10、
20、50
The minimum weighing division can
be any one of 1、2、5、10、20、50.
C1.MA
X
Full capacity
10000
100-900000
The maximum range of weighing;
This setting value ＋9d（9 个分度）
can be displayed.
While the weight exceeds the above
value, it can not be displayed.
C1.ZEr
o
Zero
calibration
0.1mV
0.05uV-15mV
The voltage that is input from the load
cell at zero is deci
ded in the zero
calibration. The unit is mV.
C1.SPA
n
Capacity
calibration
10000
100-900000
In the calibration in kind, the voltage
input from the load cell is decided in
the capacity calibration.
It is the difference between weighing
point and zero point. The unit is mV.
7.5. Parameter List of Digital Calibration
Table 7-3
CAL2
Name Default
Setting
Parameter range
Descriptions
C2.dEC
i
Position
of decimal point
0
0-4
0：No decimal place 12345
1
：
1 decimal places 1234.5
2
：
2 decimal places 123.45
3
：
3 decimal places 12.345
4：4 decimal places 1.2345
C2.d
Division
1
1、2、5、10、
20、50
The minimum weighing division
can be any one of 1、2、5、10、
20、50.
C2.MA
X
Full Capacity
10000
100－900000
The maximum range of
weighing;
This setting value ＋9d（9 个分
度）can be displayed.