enter the hi-hi limit value setting; press
、 、
to input the hi-hi limit lag; press
to clear the hi-hi limit lag input, and enter the sixth step directly; or press to confirm the
input and enter the sixth step.
Step 6
：
the Higher Limit Lag Setting
“LAg-HH” is displayed, and press to jump over the higher limit lag setting; press to
enter the higher limit value setting; press
、 、
to input the higher limit lag; press
to clear the higher limit lag input, and enter the seventh step directly; or press to
confirm the input and enter the seventh step.
Step 7
：
the Lower Limit Lag Setting
“LAg-L” is displayed, and press to jump over the lower limit lag setting; press to
enter the lower limit value setting; press
、 、
to input the lower limit lag; press
to clear the lower limit lag input, and enter the eighth step directly; or press to confirm the
input and enter the eighth step
。
Step 8
：
the Lo-lo Limit Lag Setting
“LAg-L” is displayed, and press to jump over the lo-lo limit lag setting; estimate the
higher/lower limit parameters; if it answers for the conditions (hi-hi limit value≥higher limit
value≥lower limit value≥lo-lo limit value, and the lag is in the range of 0-100), “End”will be
displayed about 2 seconds and get back to “SEt”interface; if it doesn’t answer for the conditions,
“Er.r.”will be displayed for about 2 seconds and get back to the first step automatically; press
to enter the lo-lo limit lag setting; press
、 、
to input the lo-lo limit lag; press
to clear the input, and estimate the higher/lower limit parameters; if it answers for the
conditions (hi-hi limit value≥higher limit value≥lower limit value≥lo -lo limit value, and the lag
is in the range of 0-100), “End”will be displayed about 2 seconds and get back to “SEt”interface;
if it doesn’t answer for the conditions, “Er.r.”will be displayed for about 2 seconds and get back
to the first step automatically; or press to confirm the input, and estimate the higher/lower
limit parameters; if it answers for the conditions (hi-hi limit value≥higher limit value≥lower
limit value≥lo-lo limit value, and the lag is in the range of 0-100), “End”will be displayed about
2 seconds and get back to “SEt”interface.
9.2. List of Higher/Lower Limit Parameter setting
Table 9-1
To Next Page
Loading...