Longtec TR700 - Renew to the Default

TR700 Instruction Manual
52
stands for output testing, and the latter four bits correspond to the four outputs.
Press ; there’s four outputs
，
and “1111” is displayed on the LED. Use a multi-meter to test the
four circuits separately. If the circuit is on, it can work properly.
Press ; there’s no output, and “0000” is displayed on the LED. Use a multi-meter to test the four
circuits separately. If the circuit is not on, it can work properly.
8.3.9. Renew to the Default
“rEsuME”, and press to enter the default renewing setting.
Table 8-2
rE－CAL
Renew to the default of calibration parameters
rE－FunC
Renew to the default of function setting
rE－SEt
Renew to the default of upper/lower limit value
rE－CoM
Renew to the default of communication parameters
Select the corresponding parameter option of the default needed to be renewed and input correct
password, and the default can be renewed.