Look ZED 3 - Page 29

30
EN
FITTING THE CHAINRINGS
Fig 5
Take the large chainring and
position it with the left crank.
Theinscriptionsengravedonthe
chainringmustfaceinwards.
Position the exterior chainring,
taking care to align the chain’s
anti-skip cone with the right
crank.
Position the 5 specic inter-
chainringstrutsforZED3chain-
rings(black,nosplitandwidthof
3.2mm).
Take the small chainring and
position it using the left crank.
Theinscriptionsengravedonthe
chainringmustfaceinwards.
Ensure that the alignment mar-
kerisinlinewiththerightcrank.
Place1dropofthreadlock(type
Loctite243)onthethreadsofthe
chainringmountingscrew.
Screwthescrewsintotheinserts
inthecranksetwithoutforgetting
tosandwichintheinter-chainring
struts.Slowlytighteneachscrew
evenly,withoutforcingthem,toa
torqueof8Nm.
Tighten to
= 8Nm
[ A ] [ B ] [ C ]
[ D ] [ E ] [ F ]