62
Frequently Asked Questions
Viewing A/V Output
Q: I connected the A/V output cable to my TV. How do I get the image to appear on the TV?
A: You need to press the AV button
on the remote to transfer the image from the receiver
to the TV/monitor.
NOTE: It tak
es approximately 5 seconds for the image to appear on the TV/Monitor.
Q: When using A/V output, can I watch the video on the TV/monitor, and on the receiver
at the
same time?
A: When using A/V output, the LCD screen blacks out. The image
only appears on the
television screen.
System Settings
Q: Can the system display a 12-hour clock?
A: The unit only displays time in the 24-hour clock format.
Q: Can the system adjust to
daylight savings time?
A: There is no daylight savings time (DST) setting on
the system. DST must be set manually
if necessary.
Video Playback
Q: Why can't I access the saved video files on my memory card?
A: All recording must be stopped on the system before
playing back saved video files. This
also applies to Quad or screen saver viewing mode.
Q: When using Manual or Schedul
ed Recording, why does the system generate so many
video files?
A: The system records video files in 10 minute sessions (i.e. 1 hour recording will be divided
into 6
separate files.)
The reasons for this are as follows:
• It makes finding events easier/faster in case you kno
w the approximate timing of the event.
• The system needs time to record the video file to the memory card. Every time a new 10 minute
session starts, the previous 10 minute session is stored onto the memory card.
To Next Page
Loading...
Need help?
General
