Chapter 3 Installation and Wiring
XBC E-Type Main Unit 3-11 Ver. 1
3.5 PLC Mounting
Use caution in handling
Use PLC in accordance to general specification listed in manual.
Improper use, may cause electric shock, fire, malfunction, or damage of product.
1. Installation of module.
XGB PLC has a mount for 35mm width DIN rail.
a. When installing on DIN rail
i. Pull hook for DIN rail at the bottom of module and install it on DIN rail
ii. Push hook to fix the module on DIN rail after installing.
Module must be mounted to hook for fixation properly before its fixation. The module may be
damaged from over-applied force. If module is not mounted properly, it may cause malfunction.
Do not drop or impact the module case, terminal block connector.
Do not separate the PCB from case. There are no user serviceable components inside PLC.
To Next Page
Loading...
