LS Industrial Systems XBC-DR10E - Error Code

Chapter 7 Built-in High-speed Counter Function
XBC E-Type Main Unit 7-26 Ver. 1
7.2.2 Error code
1. Error occurred is saved in the following area.
Category
Device area per channel
Remark
Ch0
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
Ch7
Error code
K266
K276
K286
K296
K2186
K2196
K2206
K2216
Word
2. Error codes and descriptions
Error code
(Decimal)
Description
20
Counter type is set out of range
21
Pulse input type is set out of range
22
Requesting #1(3,)channel Run during the operation of #0(2) channel 2 phase(
* During #0(2) channel 2 phase inputting, using #1(3)channel is not possible.
23
Compared output type setting is set out of range.
25
Internal preset value is set out of counter range
26
External present value is set out of counter range
27
Ring counter setting is set out of range
* Note ring counter setting should be 2 and more.
28
Compared output min. value is set out of permissible max. input range
29
Compared output max. value is set out of permissible max. input range
30
Error of Compared output min. value>Compared output max. value
31
Compared output is set out of the default output value
34
Set value of Unit time is out of the range
35
Pulse value per 1 revolution is set out of range
Remark
▪ If two or more errors occur, the module saves the latter error code and removes
the former one.