Chapter 10 Maintenance
XBC E-Type Main Unit 10-27 Ver. 1
10.9 Forced Input/Output On and Off Function
The Force I/O function is to force physical Inputs and Outputs ON or OFF regardless of the PLC program logic
results.
USE EXTREME CAUTION WHEN FORCING I/O! THIS CAN CAUSE UNEXPECTED EQUIPMENT
OPERATION, INCLUDING EQUIPMENT DAMAGE OR PHYSICAL INJURY.
10.9.1 Force I/O setup
1. Click Online>Force I/O.
Item Description
Move to
Address
Move to the beginning and end of I/O area (P000↔P127)
Move 8 modules right/left
Move 1 module right/left
Forced I/O Enable/Disable Set whether to allow or not Force I/O
Individual I/O
Selection
Enable Select Forcing allowed
Value Select Force On or Off
Select All Set to allow Force I/O with all I/O area on
Delete to allow Force I/O with all I/O area off.
Setting device list Display I/O area set as a bit.
To Next Page
Loading...
