Chapter 7 Built-in High-speed Counter Function
XBC E-Type Main Unit 7-28 Ver. 1
c. Turn ‘ON’ the high-speed counter Enable signal (CH0:K2600) in the program.
d. To use additional functions of the high-speed counter, you needs to turn on the flag
allowing an operation command.
i. * Refer to 2) Operation Command, <9.3.1 Special K Area for High-speed
Counter>
e. For instance, turn on 2605 bit if among additional functions, rotation number function is
used.
f. Upon the setting, download program and parameter to PLC.
To Next Page
Loading...
