Caution
▶
DO NOT too tighten the tension of the HST neutral spring. It makes an excessive
braking shock due to disturb the safety operation.
▶
The additional braking function of the HST does NOT always provide constant
braking distance of the tractor. Press the brake pedal always to stop the tractor.
(5) Driving tractor on the road
When facing downhill, DO NOT place the gear lever in “Neutral” position.
When driving the tractor on a unpaved road by attaching an implement to 3-point linkage, place the
gear lever to low speed and DO NOT lift the implement up to the highest position. When the tractor
bumps an obstacle, it may cause the jolting of implement and the failure of hydraulic system.
(In this case, place the position control lever on ¾ rising position of full stroke for safety.)
Position control
lever
4
4 4
4 - 6
Connect the left/right brake pedal with brake pedal connecting pin before driving (if
fitted).
Avoid a sudden start, sudden brake and sharp turns.
Do not allow people on the tractor or on other implements.
Do not place the baggage on the tractor or implement.
Place PTO gear lever (if fitted) in “Neutral” position and put the PTO switch in “OFF”
position.
Do not use the differential lock and four wheel drive (2WD use only).
When traveling with implement on rear 3-point linkage, tighten the stabilizer to
avoid lateral movement.
When traveling with implements installed, turn slowly by wide turning radius.
While traveling, DO NOT ride your foot on the clutch pedal (if fitted) or brake pedal.
While traveling, DO NOT operate any implements such as tiller, loader, etc.
Caution
To Next Page
Loading...
Need help?
General
