For safety, the hood must be closed and
correctly latched before operating the tractor.
The hood is hinged at the rear one bar is
attached inside to support the hood for easy
access to the engine.
To open the hood, pull the hood grip and lift the
hood up and place the supporting bar to lock
position.
To close the hood, move the supporting bar to
unlock position and lay down the hood and push
it down to lock position slightly.
5-3. Access for maintenance
Hood grip
After using first 50 hours, contact your authorized dealer for maintenance if possible.
- Replace engine oil filter. (
⇒
Refer to Every 300 hour check. See page 5-14)
- Replace hydraulic oil filter. (
⇒
Refer to Every 300 hour check. See page 5-15)
- Check transmission / rear axle / hydraulics oil level
- Check front axle oil level
- Check and adjust parking brake
- Check torque of exhaust manifold bolts
5-4. First 50 hour check
Check that the hood is properly closed.
▶
After the engine has stopped completely, you have to open the hood for check.
▶
If you open the hood while the engine is running, it can cause serious damage by
the intended or unintended access to rotating shaft, pulley, V-belt, cooling fan of the
engine or engine application parts. BE CAREFUL.
Caution
5
5 5
5 - 4
- Tighten all cooling system hose connections
- Check torque of safety cab or frame mounting bolts
- Check torque of front end weight clamp bolts (Where fitted)
- Check torque of wheel bolts and nuts
- Check tire pressures and condition
- Clean radiator, oil cooler and A/C condenser cores (Where fitted)
- Check radiator coolant level and specific gravity
- Check clutch pedal free play
- Check brake adjustment and pedal equalization
- Lubricate all grease fittings
- Neutral start switches operative
To Next Page
Loading...
Need help?
General
