②
②②
② Air-bleeding from Fuel Injection
pump
1. Turn key switch to “ON” position.
2. Loosen the Air-bleed bolt.
3. After clean fuel without bubble comes out from
the Air-bleed bolt, turn key switch to “OFF”
position. And tighten the Air-bleed bolt again.
Tightening torque : 8 N.m (5.9 lb-ft)
Air-bleed bolt
▶
Cover the bleeding fuel with a rag so that it does not flow to other components.
Notice
5
5 5
5 - 22
To Next Page
Loading...
