LSIS XBF-AD08A

XGB Analog edition manual
3 - 28
3.14 Troubleshooting
3.14.1 RUN LED flickers
Error Code
(Dec.)
Error Details
Action
31#
Parameter range excess error
Adjust parameter setting range
41#
Digital input value range excess error
Adjust digital input value range
※ # indicates channel number.
3.14.2 RUN LED is off
RUN LED f lickers .
RUN LED f lickers 0.2s intervals.
It seems to be a module defect.
Contact the nearest agency or LS branch office.
RUN LED f lickers 1s intervals.
It is Run parameters setting error. Check the error code to
take action against as follows in the table below.
Yes
No
Yes
RUN LED is Off .
D/A conversion module is installed on the base
correctly?
Correctly install D/A conversion module on the base.
.
Contact the nearest agency or A/S center.
I/O information can be seen at the XG5000.
Normally operated if D/A conversion module with
error is changed to another module.
No
Yes
No
Yes
Yes
Contact the nearest agency or A/S center.