LSIS XBF-AD08A - 6.1 Pre-operation Setting Procedure

Chap. 6 Analog I/O Module (XBF-AH04A)
Chapter 6 Analog I/O Module
6.1 Pre-operation Setting Procedure
Please proceed as follows before operating analog I/O module.
XBF-AH04A
Check Performance Specifications
Wiring
Analog I/O Data Read/Write
Parameter Setting
Programming
Eternal Voltage/Current S/W Setting
Specification (6.2 Performance
Specifications)
 Operating Environment
 I/O Type and Range
 Digital Output Range
 Analog Output Range
Wiring
 Power supply (ext. DC24V)
 Analog I/O wiring
Switch Setting
 V/A I/O Type Setting
Analog I/O Test

XG5000 Special Module
Monitor Test Mode
Parameter
 XG5000 I/O Parameter
Programming
 Analog Data Read/Write Program
(U Device)
In case of error or abnormal analog input
or digital output, see Diagnosis.
6 - 1