7 Turn the voice terminal right side up, with the front facing you.
8 Decide whether you want the kickstand up, lifted from the desktop
stand, or whether you want the kickstand down, level with the
desktop stand. Check which of these kickstand adjustments allows
you the best viewing angle of the display.
9 Snap the free end of the handset cord into the handset and place the
handset in the cradle.
10 Snap the free end of the line cord into the modular jack. Lift the
handset and listen for the dial tone.
ATTACHING ADJUNCT EQUIPMENT
If you are installing a speakerphone (models Lucent S101A, S201A, or
QUORUM CS201A), a headset adapter (model Lucent 500A or the
507A adapter), or other adjunct that may be offered, follow these steps
to connect the adjunct equipment to your voice terminal.
1 Place the voice terminal face down on a flat surface.
2 Using the thumb notches beside the kickstand, lift the kickstand from
the desktop stand.
3 Pass the line cord (and adjunct cord, if applicable) under the
kickstand.
4 Snap the adjunct cord into the "ADJUNCT" jack until you hear a click.
See Figure 5 for the location of the "ADJUNCT" jack.
5 Route the adjunct cord through the channel. Refer to the "Desktop
Installation" section for instructions.
6 Connect the free end of the adjunct cord to your speakerphone or
headset adapter.
NOTE: Refer to the adjunct’s installation documentation for its power
requirements.
73
To Next Page
Loading...
Need help?
General
