Adding Memory
3-4 Communications Server Hardware Installation Guide
5. Locate the existing SIMM boards.
The SIMM boards are located in the upper right corner of the motherboard
approximately 3.5 inches to the right of the CPU.
6. Remove the existing SIMM boards.
Place your finger on the top center of the SIMM closest to the CPU and gently push
it in the direction of the CPU until the SIMM is free from its socket. Repeat with
each SIMM board until all four SIMM boards are removed.
7. Insert the new SIMM boards.
Starting with the socket farthest from the CPU, slide a new SIMM board, gold side
down, into the socket at a 45-degree angle. Once the SIMM board is seated, place
your finger on the top center of the SIMM board and gently push it away from the
CPU until it clicks into place. Repeat with each SIMM board until all four SIMM
boards are inserted.
8. Replace the lid.
Slide the lid over the outside edges of the PortMaster, and slide it towards you
until it clicks into place.
1187_0023
CPU
existing SIMM
CPU
1187_0024
new SIMM
To Next Page
Loading...
Need help?
General