Lumel RE72 User Manual

27
27
aOlo
Lower threshold of the
signal to retransmit
0.0 MIN...MAX 3)
aOHi
Upper threshold of the
signal to retransmit
100.0 MIN...MAX 3)
serp – Service parameters
seCU
Access code to the menu 0 0...9999
sTfn
Auto-tuning function
on
off: locked
on: available
timr
Timer function
off
off: disabled
on: enabled
time
Counting off the time by
the timer
30.0
min
0.1...999.9 min
Di2
Monitoring of the auxiliary
input
off
off: disabled
on: enabled
DCt
Monitoring of the heater
current
off
off: disabled
on: enabled
tout
Time of the automatic out-
put from the monitoring
mode
30 s 0...9999 s
1) The definition at which the given parameter is shown depends on the parameter
dp – position of the decimal point.
2) For the output 0/4...20 mA, parameter to write, for other cases, to readout
– acc. to the version code.
3) See table 2.
4) Time unit defined by the parameter sPmd (Rmin, RHr).
5) Applies to binary output
6) Applies to analog output
7)
For control alg = oNof and Yfl <= 50% , control signal h = 0%,
Yfl > 50%, control signal h = 100%
.
Caution! The accessibility of parameters depends on the controller
version and its current settings.

Lumel RE72 Specifications

General

Brand	Lumel
Model	RE72
Category	Controller
Language	English