display (acc. to the fi g. 13.) The return to display the set point value is
set by the manufacturer for 30 sec, but it can be changed, or disabled
through the parameter tout.
7.3. Binary Inputs
The function of the binary input is set by the parameter bNin.
Following binary input functions are available:
- without function – the binary input state does not infl uence
the controller operation,
- control stop – the control is interrupted, and control outputs are
behaved as after a sensor damage, alarm and retransmission operate
independently,
- switching on manual operation – transition to the manual control mode
- switching SP1 on SP2 – change of the set point value during the control,
- erasing of the timer alarm – disabling of the relay responsible for
the timer alarm,
- program start – the programming control process begins (after a prior
set of the programming control),
- jump to the next segment – the transition to the next segment,
follows during the duration of programming control.
- stoppage to count the set point value in the program –
the stoppage of set point value counting follows during the duration
of the programming control.
To Next Page
Loading...
Need help?
General
