For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI® Control Unit Quick Installation and Operation Guide
10
Programming Mode
Entering and Exiting Programming Mode
Entering programming mode
Press and hold the top and bottom scene buttons
simultaneously for 3 seconds. The LEDs in the scene
buttons will scroll from top to bottom, confirming that you
are in programming mode, and the info screen will display
the main menu.
Exiting programming mode
Press and hold the top and bottom scene buttons
simultaneously for 3 seconds. The info screen will go to
Scene 1.
Navigating Menus in Programming Mode
Master Buttons
The Master buttons allow you to move through the menu choices. The current
choice is highlighted on the info screen.
OK Button
The OK button chooses the current highlighted menu choice. This will either take you to the next menu or accept a setting you have
selected. When the screen displays a Yes/No question, the OK button is “Yes”.
Timeclock Button
The timeclock button functions as a “back” button during programming mode. Pressing the timeclock button takes you back one step in
the current menu. Pressing it repeatedly will eventually return you to the main menu, but will not exit programming mode. When the screen
displays a Yes/No question, the Timeclock button is “No”.
Main Menu
Timeclock
Scene Setup
Scene 1
Fade Time
3 Seconds
OK
16
9-16
1-8
Master buttons
OK button
Timeclock (back)
button
Press and hold the
top and bottom
buttons for 3 seconds
to enter or exit
programming mode
To Next Page
Loading...
