For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI® Control Unit Quick Installation and Operation Guide
11
Wireless Mode
Many models of the GRAFIK Eye QS control unit support wireless communication
with other Lutron products. This feature allows for easy integration of wireless
sensors, keypads, remotes, and window treatments for single-room wireless
applications.
Units supporting wireless communication are labeled “GRAFIK Eye QS Wireless”
on the front label of the unit.
The wireless feature of the GRAFIK Eye QS Wireless control unit has three (3)
modes of operation.
• Disabled: Use for wired-only systems.
• Enabled: The GRAFIK Eye QS Wireless control unit will respond to any
programming commands from nearby Lutron QS wireless (and compatible)
products.
• Ignore Programming (default): The GRAFIK Eye QS Wireless control unit operates normally but ignores any wireless devices in
programming mode.
Changing the wireless mode of the GRAFIK Eye QS Wireless control unit
1. Enter programming mode.
2. Use the Master buttons to highlight “Wireless Mode” and press the OK button to accept.
3. Use the Master buttons to highlight the desired wireless mode, and press the OK button to accept.
4. The info screen will display a confirming “Saved” message.
5. Exit programming mode.
Note: The wireless signal has a range of 9 m through standard construction or 18 m line-of-sight.
Main Menu
Shade Labels
Wireless Mode
Saved
Wireless Mode
Enabled
OK
16
9-16
1-8
Master buttons
OK button
Timeclock (back)
button
To Next Page
Loading...
