For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI® Control Unit Quick Installation and Operation Guide
15
DALI® Setup (continued)
Assigning/Unassigning a DALI® Device to a Zone
DALI® devices must be addressed on the system (see previous page) before
assigning or unassigning to a zone.
1. Enter programming mode.
2. Use the Master buttons to highlight “DALI” and press the
OK button to accept.
3. Use the Master buttons to highlight “Assign zones” and
press the OK button to accept.
4. Use the Master buttons to scroll through the DALI
®
devices on the link. The selected device will flash, and
the info screen will display the device number and the
number of devices on the link. If the device is currently
assigned to a zone, the zone number will display at the
bottom of the screen and the LEDs for the zone will go
on; otherwise, the info screen will display “*Unassigned*”.
• Press the zone raise button to assign the device to that
zone.
• Press the zone lower button to unassign the device to
that zone.
5. Press the timeclock (back) button to return to the DALI® menu. DALI® devices will return to normal levels.
6. Exit programming mode.
Notes
• Devices that were previously assigned to a zone will be removed from the old zone and assigned to the new zone
(each device can be assigned to only 1 zone at a time).
• Devices can be assigned only to zones set to DALI® load type.
• Refer to the Zone Setup section for instructions on changing load type.
Main Menu
Zone Setup
DALI
DALI
Assign Zones
Address All
Assign zones
Ballast 2/23
*Unassigned*
Assign zones
Ballast 2/23
Zone 3
OK
16
9-16
1-8
Master buttons
OK button
Timeclock (back)
button
12
3
4
5
To Next Page
Loading...
