For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI® Control Unit Quick Installation and Operation Guide
17
Occupancy Sensor Setup (continued)
Scene Mode
This step allows you to assign up to four occupancy sensors to the GRAFIK Eye
QS control unit.
Selecting Sensors
1. If not already done, associate occupancy sensors and set
to “Scene Mode”.
2. Use the Master buttons to highlight “Setup” and press
the OK button to accept. The info screen will display
“Searching” while the unit detects available occupancy
sensors.
3. Use the Master buttons to scroll through the list of available occupancy sensors. When the desired sensor is
displayed, press the OK button to select it. Then choose “Assign” or “Unassign” from the following menu and
press OK. Once a sensor has been assigned, it will appear with an asterisk (*) in the sensor list. Repeat for
additional sensors.
Note: If wireless sensors are not found, verify that they are associated correctly.
Setting the Sensor Action
1. Press the Timeclock (back) button to return to the Occ Sensor screen. Use the Master buttons to highlight
“Actions” and press the OK button. By default, the occupied scene is set to “No Action” and the unoccupied
scene is set to “Scene Off”.
2. Use the Master buttons to highlight the scene you wish to use for occupied status and press the OK button to
accept. Repeat for the scene you wish to use for unoccupied status. Press the OK button to accept.
3. Exit programming mode.
Occ Sensor
Setup
Labels
Assignment
Assign
Unassign
Searching
*Assigned*
Sensor x/y
xxxxxxxx
yyyy-yyyy
RF
Sensor *x/y
xxxxxxxx
yyyy-yyyy
RF
Occ Sensor
Actions
Setup
Occupied Scene
No Action
Unoccupied Scene
Scene Off
Saved
OK
16
9-16
1-8
Master buttons
OK button
Timeclock (back)
button
To Next Page
Loading...
