Lutron Electronics GRAFIK Eye QS - QS Link Control Wiring Details

For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI® Control Unit Quick Installation and Operation Guide
7
Wiring the GRAFIK Eye QS with DALI® Control Unit:
QS Link Control Wiring Details
• System communication uses IEC PELV wiring.
• Follow all local and national electrical codes when installing IEC PELV wiring with
line voltage/mains wiring.
• Each QS link terminal can accept
only two 18 AWG (1.0 mm
2
)
wires (two 12 AWG [4.0 mm
2
]
conductors will not fit). Connect
using appropriate wire connectors
as shown to the right.
• Total length of control link must
not exceed 610 m.
• Make all connections in the
control unit’s wallbox.
• Wiring can be T-tapped or
daisy-chained.
• IEC PELV 24 V- 150 mA.
System Limits
The QS wired communication
link is limited to 100 devices or
100zones.
The GRAFIK Eye QS control unit supplies 3Power
Draw Units (PDUs) on the QS link. Refer to the
QS Link Power Draw Units specification submittal
(Lutron P/N 369405) for more information about
Power Draw Units.
Wire Sizes (check compatibility in your area)
QS Link Wiring Length Wire Gauge Lutron Cable Part Number
Less than 153 m Power (terminals 1 and 2): 1 pair 1.0 mm
2
GRX-CBL-346S; GRX-PCBL-346S
Data (terminals 3 and 4): 1 twisted, shielded pair 0.5 mm
2
153 to 610 m Power (terminals 1 and 2): 1 pair 4.0 mm
2
GRX-CBL-46L; GRX-PCBL-46L
Data (terminals 3 and 4): 1 twisted, shielded pair 0.5 mm
2
T-Tap Wiring Example
LUTRON
LUTRON
LUTRON
LUTRON
LUTRON
GRAFIK Eye QS with
DALI® control unit
Sivoia QS
window
treatment/
drape
seeTouch QS
wallstation
To DALI® link 1
To DALI® link 2
QS smart
power
panel
Daisy-Chain Wiring Example
LUTRON
LUTRON
LUTRON
LUTRONLUTRON
LUTRON
LUTRON
seeTouch QS
wallstations
QS smart
power panel
GRAFIK Eye QS
with DALI®
control unit
GRAFIK Eye QS
with DALI®
control unit
To DALI® link 1 To DALI® link 2
Sivoia QS
window
treatment/
drape
4.0 mm
2
1.5 mm
2