Lutron Electronics GRAFIK Eye QS - Wiring Overview for GRAFIK Eye QS with DALI; Overview of Line Voltage;Mains and DALI Wiring

For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI® Control Unit Quick Installation and Operation Guide
3
Wiring the GRAFIK Eye QS with DALI® Control Unit:
Overview of Line Voltage/Mains and DALI® Wiring
Two D1 and two D2 connections are provided for ease of wiring, and to provide two connecting points; there is only one
DALI® link on the unit.
Line Voltage/Mains
Cables and Load Wiring
DALI
® Bus
Wiring
(See DALI® Bus
Wiring Details
section for complete
specification)
Terminal labels
L: Line / Hot
N: Neutral
: Ground
To additional DALI® devices
DALI® devices:
ballasts, drivers, or interfaces
Distribution
Panel
D2
L
L
N
N
D2
D1
D1
2.5 mm
2
each terminal
230V~
50/60Hz
Distribution
Panel
Two 1.5 mm
2
each terminal*
* See page 7 for additional wiring options.