Mabit SmartControl - Default Chapter; Table of Contents

To Next Page

To Previous Page

- 2 -

MAB 2010280101 EN V2.2

www.mabit.pl

info@mabit.pl

1. Safety information...................................................................................................................- 4 -

2. Introduction.............................................................................................................................- 5 -

2.1. Main features ...................................................................................................................- 5 -

2.2. Ordering ...........................................................................................................................- 6 -

2.3. Nameplate........................................................................................................................- 9 -

3. Technical data ......................................................................................................................- 10 -

3.1. Technical data of SmartControl......................................................................................- 10 -

3.2. Technical data of Hand wheel........................................................................................- 11 -

3.3. Technical data of butli-in emergency off switch/stop (IDEC)..........................................- 12 -

3.4. Technical data of butli-in enabling switch (IDEC)...........................................................- 13 -

3.5. Technical data of USB cable for programming SC5-PROG...........................................- 14 -

3.6. Technical data of interface separating signals SC5-INT................................................- 15 -

3.7. Technical data of SC5-CAB cables................................................................................- 16 -

3.8. Technical data of automatic work mode switch SC5-AUT .............................................- 17 -

4. Wiring....................................................................................................................................- 18 -

4.1. Connecting the cable to SmartControl ...........................................................................- 18 -

4.2. Connection to controller/ machine..................................................................................- 22 -

4.2.1 Connection with SC5-CAB-N-AAA cable..................................................................- 22 -

4.2.2 Connection with SC5-CAB-S-AAA cable..................................................................- 23 -

4.2.3. Connection with SC5-CAB-D-AAA cable.................................................................- 23 -

4.2.4 Connection of SC5-INT Interface. ............................................................................- 24 -

4.3. Connection of automatic machine work mode switch SC5-AUT....................................- 26 -

4.3.1 SC5-AUT connection pattern .......................................................................................- 26 -

4.3.2 Example of safety system with automatic work mode switch..................................- 26 -

5. Installation.............................................................................................................................- 27 -

5.1. SmartControl – dimensions............................................................................................- 27 -

5.2. SmartControl – methods of fixing on the machine .........................................................- 28 -

List of contents