SC5-INT
Interface separating signals and power supply in the switch
cabinet, for installation on DIN rail
SC5-CAB-N-AAA
Cable for connecting SmartControl with the machine, without plugs ended with free wires with cable gland ( AAA is length in cm )
[ 1500 = 15m ]
SC5-CAB-S-AAA
Cable for connecting SmartControl with the machine, with 26pin plug for connecting SC5-INT interface and with cable gland
(AAA is length in cm ) [ 1500 = 15m ]
SC5-CAB-D-AAA-BBB
Two-piece cable for connecting SmartControl with the machine, with IP67 D-sub plug, socket for installation in the switch cabinet
and 26pin plug for connecting SC5-INT interface (AAA is length in cm from SmartControl to the socket, BBB length in cm from
the socket to the SC5-INT interface) [ 1500 = 15m ]
SC5-AUT
Automatic machine work mode switch (the switch is
permanently fixed outside the danger zone, after taking
SmartControl off the switch, the machine switches to manual
control whereby using the enabling switch is necessary e.g. for
starting drives ). It has the cable gland.
To Next Page
Loading...