CAB DISPLAY MODULE (CDM)
4.7 Troubleshooting Windrower Problems
4.7.1 D isplaying the Windrower and Engine Error Codes
NOTE:
The header MU
ST be attached to the windrower to perform this procedure.
1. Turn ignition key to RUN, or start the engine .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode. Press
SELECT (C).
• WINDROWER SETUP? is displayed on the
upper line.
3. Press S ELE CT (C) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is dis playe d on the lower lin e .
Figure 4.230: M105 CDM Programming Buttons
Figure 4.231: M155 CDM Programming Buttons
Figure 4.232: M205 CDM Programming Buttons
147962 253 Revision A
To Next Page
Loading...
