ASSEMBLING THE WINDROWER
11. Open the circuit breaker/fuse box (A), and remove the
engine control module (ECM) ignition fuse (5A) (B).
CAUTION
Check to be sure all bystanders have cleared the area.
12. Prime the system by cranking the engine with the
starter for 15 seconds.
13. Reconnect the electrical connection at the fuel pump
and at the brake engage solenoid.
14. Reinstall ECM ignition fuse (5A) (B) and the circuit
breaker/fuse box (A).
15. Close the engine compartment hood.
Figure 3
.126: Circuit Breaker/Fuse Box
16. Check the hydraulic oil level in the reservoir (remove
filler ca p/dip stick (A) a nd add SAE 15W-40 oil if
necessary). Refer to 5.5 Checking Hydraulic Oil, page
327.
17. Close the left-hand (cab-forward) platform.
Figur
e 3.12 7: Filler Cap/Dipstick
147962 83 Revision A
To Next Page
Loading...
